Brey Krause R-1025 - Harness Truss/ Harness Mount for 911 Coupes

Make	Model	Note	Year
PORSCHE	911	Coupe	1974-1989
PORSCHE	964	911 Coupe	1989-1994
PORSCHE	993	911 Coupe	1994-1998

Harness Mount Truss, 1974-1998 Porsche 911 Coupe: R-1025: BK Logo

The Brey-Krause "Harness Truss" was developed so a driver can mount the shoulder harness directly to the truss. This provides proper mounting of the harness and is much more than just a guide bar.

The Harness Truss has been tested and certified to handle the types of forces required by the National Highway Traffic Safety Admin. DOT and SAE J385 Rev.MAR 95, Motor Vehicle Seat Belt Anchorages-Performance Requirements. It's strong, yet it weighs only a fraction of what a support of the same strength made from tubular or bar steel would weigh.

The Harness Truss is precision water-jet machined for a perfect fit into Porsche factory mounting points. This type of machining is accurate and does not create heat affected areas in the metal which can alter tensile strength. Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. A mount really can't be relied upon unless it has been tested to support the loads required by the National Highway Traffic Safety Administration.

Material: 6061-T6 aluminum skeleton and reinforcing bar. Type 304 stainless steel brackets.

Finish: Anodized aluminum with satin stainless mounting brackets.

Weight: 9.44 lbs.

Models: 911 Coupes '74 - '98

Installation: Bar attaches to factory mounting points in "B" pillars.

Miscellaneous: Harness Truss is designed to allow enough seat travel for tall drivers. The stainless steel mounting brackets can be left installed in the "B" pillars to easily remove and remount the bar in minutes.

Click here for Installation Instructions

Below are related products you may want to consider.

Check the check boxes next to the additional products that you would like to add to the shopping cart, then click on the "Add to Cart" button above. A check box is not shown if a product requires that you select an option or fill out a field. (

) indicates a required accessory.

Brey Krause R-9035 - Anti-Sub Strap Mount - Porsche 964, 993, 911

Price $158.52

Brey Krause R-9001 - Tunnel Side Belt Mount Kit - Porsche

Price $110.28

Brey Krause R-9003 - Outside Belt Mount Kit - Porsche

Price $110.28

Brey Krause R-9004 - Tunnel Side Belt Mount Kit, Extra Short - Porsche

Price $110.28

Product Reviews

Write your own review

Rate this product: Like it

Like it

Don't like it

Fitment Information

Make	Model	Note	Year
PORSCHE	911	Coupe	1974-1989
PORSCHE	964	911 Coupe	1989-1994
PORSCHE	993	911 Coupe	1994-1998

Description

Harness Mount Truss, 1974-1998 Porsche 911 Coupe: R-1025:

The Brey-Krause "Harness Truss" was developed so a driver can mount the shoulder harness directly to the truss. This provides proper mounting of the harness and is much more than just a guide bar.

Material: 6061-T6 aluminum skeleton and reinforcing bar. Type 304 stainless steel brackets.

Finish: Anodized aluminum with satin stainless mounting brackets.

Weight: 9.44 lbs.

Models: 911 Coupes '74 - '98

Installation: Bar attaches to factory mounting points in "B" pillars.

Click here for Installation Instructions