Brey-Krause Seat Side Mount for BMW E36 sliders, 440, 427mm wide: R-9240

Material: 11 gauge, type 304, stainless steel

Finish: Powder-coated black wrinkle-finish

Weight: 6.5 lbs
Models: Mounts seats with a width between 440mm and 427mm to BMW E36 floor
Miscellaneous: Because of their different seat mount points, Sparco seats tend to sit high with the R-9240 seat mounts while Recaro seats mount low. We recommend tall drivers use Recaro seats and short drivers use Sparco seats. Average height drivers should be fine with either.

The R-9240 fits seats between 427mm and 440mm wide at the side mount mounting point. This includes, but is not limited to:
Recaro Profi XL
Recaro Pole Position
Recaro Pro Racer Hans XL SPA
Recaro Pro Racer Hans XL

Features and Benefits:

-The R-9240 seat mount is clean, simple, light weight, and strong way to attach your fixed back bucket seats directly to the floor of your E36 BMW. Instead of using long slots and tons of holes to create a one size fits all generic solution, they are made specifically to fit in a small number of car chassis and work with a limit range of seat sizes to create a precise fit.

-The R-9240 seat mount bolts directly to the floor using the stock BMW hardware. No floor mount adaptor or alternation to the car is required.

-The R-9240 seat mount provides all necessary mounting locations for the 3 point seatbelt. These mounting points can be used to mount lap belts for the 4, 5, or 6 points as well. Sub strap mounting is possible when using the R-9259 Sub Strap Mount (sold separately). This system allows for the use of the stock 3 point seat belt in conjunction with 4, 5, or 6 point harnesses.

-Due to not using a floor mount adaptor or sliders, the R-9240 seat mounts allow your seat to be mounted lower than any other mounting solution we've seen.

-The R-9240 seat mount weighs 6-7 lbs per seat. Traditional adaptor/slider/mount/belt mount point solutions can often weigh in excess of 20 lbs per seat.

-The rear seat mounting holes, which take the majority of the load in a crash, are not slotted, adding considerable strength.

-The R-9240 seat mount line has been tested and certified by an independent lab to handle the types of forces required by the National Highway Traffic Safety Admin. DOT and SAE J385 Rev.MAR 95, Motor Vehicle Seat Belt Anchorages-Performance Requirements.

-If a fire extinguisher mount is desired, all R-9240 seat mounts include provision to attach the R-2295 fire extinguisher mount. This mount can be used with either our R-9520/9530 quick release mount or the stock 3 lb Amerex bottle mount.

Related Parts:
R-9259 Sub Strap Mount for R-9240 Side Mount
R-2295 Fire Extinguisher Mount for R-9240 Side Mount

Installation Instructions